Our steering wheel was designed for good looks, ease of installation and cost effectiveness. This realistic 12” diameter, dished wheel is scaled for child use. It comes with 3/8″ lag screw for mounting hardware and has a horn button cap to provide a finished appearance after installation. Unlike some of its blow molded competitors, our injection molded wheel has the strength and substantial feel normally associated with the real thing.  This product should last 2 years in harsh conditions and up to 5 years in optimal conditions. Some conditions may require replacement sooner.  Tensile strength is 1377 lbs..

Parts List

1 – Plastic Steering Wheel

1 – Hub

Colors:                       Blue, Green, Red, and Yellow


This is for children 2 – 12 years old only. Adults should supervise children at all times. Do not allow children to use unsafely. Do not allow it to be used if damaged.

IMPORTANT: Please read for important information. In this material we have tried to provide some requirements stated in the CPSC Handbooks, ASTM F2373-11, F1487-11 and F1148-09. However, we in no way intend for this to be a complete list of requirements. Also these publications are updated frequently with changes therefore, you should read these publications yourself to determine if any part or installation could prove a danger to a child.

To help keep children safe from harm, review installation and maintenance instructions before installing equipment. These are located in the description of every product on our website.   Download and print these instructions and keep in a safe place. Our website also has a “Product Testing Information” page. All products are tested for lead, phthalates and tensile strength. You can also call us at 1-800-227-7529 for more information or see

Due to the thermo dynamics and lower heat transfer properties of plastics, plastic wheels are preferred over metal wheels for play equipment. Although plastic wheels may become as hot as metal, they insulate better and don’t transfer the heat as quickly. Because of these properties, the Consumer Product Safety Commission (CPSC) recommends plastic and plastic surfaces over bare metal.

Regardless of lower heat transfer properties, plastic play equipment can still become hot enough ‐‐ in extreme temperatures and direct sunlight ‐‐ to cause burns.  As is the case with all playground equipment, parents and supervisors must monitor the children in their care, make certain that the equipment is appropriate for their age, and always check playground surfaces for excessive heat before allowing children to play.  For more information, contact IPEMA headquarters at or by calling 17172381744.

Installation: Our parts are sold as either replacement parts or components of a set, unless you are buying our Metal Frame Set, therefore these parts need to be installed according to the sets installation instructions. If the installation instructions differ from ours please contact us at 800-227-7529.

Make sure that you are attaching the steering wheel to wood that is strong enough to support the weight of the wheel and spinning motion. Drill a starter hole in the wood. Place a washer next to top of wood, then steering wheel. With a socket wrench screw, supplied 3/8” lag, screw completely into wood. Pop on horn button cap. Make sure that steering wheel can spin freely.

Maintenance: At beginning and end of each play season and once a month during play season, check that steering wheel can spin freely. Check for vandalism, for sharp edges or cracked plastic. Make sure lag screw is secure. Replace parts as necessary.

Any damage from vandalism, abuse or misuse VOIDS all warranties.

Weight (lbs) 1.25
Dimensions (in) 12 × 14 × 4 in