Special feet for swing frames to be used inside. They will prevent floors from marring. Part included are: 4 pieces of pipe with a 2” plastic plug inserted, 4 bases, 8 – 3/8” washers, 4 – 3/8” – 16 x 3” bolt, 4 – 3/8” nuts. This product should last 2 years in harsh conditions and up to 5 years in optimal conditions. Some conditions may require replacement sooner. Sold as Set of 4.
This is for children 0-12 years old only. Adults should supervise children at all times. Any set that is placed above ground is not meant to be used with a normal swing only with a Jennswing or an infant seat. Our above ground swing frames are not designed for vigorous swinging. They are designed for swinging within the “A” of the frames.
IMPORTANT: To keep children safe from harm, follow these precautions and instructions when installing, using, or maintaining this playground equipment. You can also call us at 1-800-227-7529 for more information or see http://www.cpsc.gov/cpscpub/pubs/324.pdf.
Installation: Our parts are sold as either replacement parts or components of a set, unless you are buying our Metal Frame Set, therefore these parts need to be installed according to the sets installation instructions. If the installation instructions differ from ours please contact us at 800-227-7529.
Thread each base piece to each pipe and plug. Insert each assembled feet into each frame leg. The fit should be snug and you may need to use a rubber mallet to insert the foot completely. Line up the holes in each pipe. Insert the 3/8” bolts with washers on each side through both the pipe and the rubber plug. Tighten with nut to hold in place. Bolt should not protrude past nut more than two threads. Put plastic cap over nut to prevent injury. If feet are purchased separately from our frames, you will need to drill your own 3/8” holes. Drill a 3/8” hole through the pipe and the rubber plug. Insert a 3/8” bolt with washers on each side through both the pipe and the rubber plug. Tighten with nut to hold in place. Bolt should not protrude past nut more than two threads. Put plastic cap over nut to prevent injury. The feet can be adjusted by loosening the nuts on the base of the feet, and then threading the base in the desired direction. Make sure to tighten the nuts when you are done.
Maintenance: At beginning and end of each play season and once a month during play season, check for sharp edges and or cracked plastic. Make sure feet have a tight fit in pipe. Check that screws are secure, and the caps have not been loosened or removed. Check for rust. Take a wire brush or piece of steel wool and scrub rust from metal surfaces. Check for vandalism and missing parts. Replace parts as necessary.
Any damage from vandalism, abuse or misuse VOIDS all warranties.
| Weight (lbs) | 14 |
|---|---|
| Dimensions (in) | 11 × 9 × 6 in |
